Friendly Charger For Mobile Smart Phone

Most mobile chargers do not have current/voltage regulation or short-circuit protection. These chargers provide raw 6-12V DC for charging the battery pack. Most of the mobile phone battery packs have a rating of 3.6V, 650 mAh. For increasing the life of the battery, slow charging at low current is advisable. Six to ten hours of charging at 150-200mA current is a suitable option. This will prevent heating up of the battery and extend its life.

The circuit described here provides around 180 mA current at 5.6V and protects the mobile phone from unexpected voltage fluctuations that develop on the mains line. So the charger can be left ‘on’ over night to replenish the battery charge.


The circuit protects the mobile phone as well as the charger by immediately disconnecting the output when it senses a voltage surge or a short circuit in the battery pack or connector. It can be called a ‘middle man’ between the existing charger and the mobile phone. It has features like voltage and current regulation, over-current protection, and high and low voltage cut-off. An added speciality of the circuit is that it incorporates a short delay of ten seconds to switch on when mains resumes following a power failure. This protects the mobile phone from instant voltage spikes.
The circuit is designed for use in conjunction with a 12V, 500mA adaptor (battery eliminator).
Op-amp IC LM741 is used as a voltage comparator. The inverting input of IC1 is provided with a variable voltage obtained through the wiper of potmeter VR1. The non-inverting input of IC1 is connected to 12V stabilised DC voltage developed across zener ZD1. This makes the output of IC1 high.

After a power resumption, capacitor C1 provides delay of a few seconds to charge to a potential higher than of inverting of LM741, thus the output of IC1 goes high only after the delay. In the case of a heavy power line surge, zener diode ZD1 (12V, 1W) will breakdown and short of IC1 to ground and the output of IC1 drops to ground level. The output of IC1 is fed to the base of npn Darlington transistor BD677 (Q2) for charging the battery. Transistor Q2 conducts only when the output of IC1 is high. During conduction the emitter voltage of Q2 is around 10V, which passes through R6 to restrict the charging current to around 180 mA. Zener diode ZD2 regulates the charging voltage to around 5.6V.

When a short circuit occurs at the battery terminal, resistor R8 senses the over current, allowing transistor Q1 to conduct and light up LED1. Glowing of LED2 indicates the charging mode, while LED1 indicates short circuit or over current status.

The value of resistor R8 is important to get the desired current level to operate the cut-off. With the given value of R8 (3.3 ohms), it is 350 mA. Charging current can also be changed by increasing or decreasing the value of R7 using the ‘I=V/R' rule.

Construct the circuit on a common PCB and house in a small plastic case. Connect the circuit between the output lines of the charger and the input pins of the mobile phone with correct polarity.

Untuk Pemesanan Friendly Charger For Mobile Smart Phone Silahkan KLIK DISINI